KSGER T12 stand

#KSGER T 12 Stand

I wanted a stand for my KSGER T12 that matched the angle of the handle holder. I bought the holder off [Banggood](https://www.banggood.com/Soldering-Iron-Stand-Welding-Holder-for-FX951-T12-Soldering-Station-Handle-p-1156336.html)

The unit is held in place by friction in my print, there is tabs on the back of the slot that should stop it from sliding out of it's not a tight fit. If your filament shrinks a lot, or if you know you typically end up with undersized prints, you might want to bump the size by a 1% or so in your slicer.

It will print without any supports if you place the back on the print bed (see the Cura placement image).

It took around 12hrs to print on my Ender 3