MakerWorld
Vehicles
Model downloaden
KTM 690 ABS Guard Front
15
Downloads
9
Likes
8
Makes
I printed in PLA+ and it lasted months in the tropical sun with some slight warpage.Have since reprinted in ASA which should hold up better, I would have been find leaving the PLA+ though.I have one for the rear too:https://www.printables.com/model/1247128-ktm-690-abs-guard-rear 5 walls, 5 bottom, 5 topNo supports needed
GilliGainz publiceert ook op
27 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
