Thingiverse
KTM Fork Guard Clamp Cap
by macfxr
0
Downloads
1
Likes
0
Makes
This is a cosmetic finishing cap to cover the open cable guide on the left fork protector of a KTM fork guard.
My particular application was a KTM 1090 that had a high fender kit installed - didn't like the look of the two channels, slot and open screw holds - so I made a cap.
Costs about .07 in material and 15 min to prep/print - if you like it, great. If not - toss it.
Turns out that in the end the fit and finish is not that great. Will redesign at some point.
My particular application was a KTM 1090 that had a high fender kit installed - didn't like the look of the two channels, slot and open screw holds - so I made a cap.
Costs about .07 in material and 15 min to prep/print - if you like it, great. If not - toss it.
Turns out that in the end the fit and finish is not that great. Will redesign at some point.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
