Thingiverse
Kubotan - printable
von Ryman
56
Downloads
46
Likes
0
Makes
An altered version of heileh's kubotan, made to be printable by most 3d printers without supports.
Original here:
http://www.thingiverse.com/thing:865700
Supports added in at the tip because it was still a sharp angle to print at, the flat side doesn't cut down on your ability to hold it much, I find.
I wanted it to be able to print while laying down length-wise because it seemed to me that standing it upright would make the layers more susceptible to being snapped apart.
Original here:
http://www.thingiverse.com/thing:865700
Supports added in at the tip because it was still a sharp angle to print at, the flat side doesn't cut down on your ability to hold it much, I find.
I wanted it to be able to print while laying down length-wise because it seemed to me that standing it upright would make the layers more susceptible to being snapped apart.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
