Kulp K8-PB V2.0.0 Mount

This mount is a little tricker to print than normal ones. Please Read.

Two options exist.

This board has a very small capacitor very close to the mounting whole on the underside. Traditional stand-offs would risk putting pressure on the solder joints and/or the capacitor itself.

The first just provides support for the the bottom right corner but nothing through the hole. Easier to print.

The second option to get around this, the bottom-left mounting hole uses a thinner post and guide for the board to rest on. It does not utilize a screw in this corner but simply provides support.

This detail is small on the mount. You will want to adjust your print settings. I use a finer detail layer width and when it gets to the post I slow the printer down so that it prints cleanly. If printed cleanly it should slide right through the hole and sit on the platform. If not, you will likely need to clean up the post.