Thingiverse
Kuro's i3 X axis
door kuro
12
Downloads
10
Likes
0
Makes
As I kept modifying my i3, I've reached the point where I am satisfied with this X axis.
Just print all the parts with layer height equal or lower than 0.3mm and extrusion width 0.5mm or lower.
These parts are made so the bearings/bushings are fixed with zip ties.
It can be a little tricky to put the zip ties in the holes. The way I do it is by bending the point of the tie so it looks like a J, like a hook.
If you have problems fixing the nut, use a soldering iron on it until it aligns with the hole.
The tensioner is made so two 624 or F624 bearings fit side by side.
Just print all the parts with layer height equal or lower than 0.3mm and extrusion width 0.5mm or lower.
These parts are made so the bearings/bushings are fixed with zip ties.
It can be a little tricky to put the zip ties in the holes. The way I do it is by bending the point of the tie so it looks like a J, like a hook.
If you have problems fixing the nut, use a soldering iron on it until it aligns with the hole.
The tensioner is made so two 624 or F624 bearings fit side by side.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!