Thingiverse
Kyber Crystal - Model Paint Stand
por tinkererscove
8
Descargas
2
Likes
1
Makes
This is a simple stand designed for holding small models - in our case - split body kyber crystals. This is a simple print and completes in under an hour. The pegs are just offset to the main body and are half the diameter of the peg holes. You can either double up the pegs or save a few as spare and use them in half.
A small dab of super glue will hole them in place. Allow to cure and they are plenty strong to hold items while painting. Printed at 5% infill and designed to use minimal motion and filament assuming you orient properly.
A small dab of super glue will hole them in place. Allow to cure and they are plenty strong to hold items while painting. Printed at 5% infill and designed to use minimal motion and filament assuming you orient properly.
tinkererscove también publica en
23 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
