L298N Motor Controller Board Clip
di matthewtmead
91
Download
61
Likes
0
Makes
This is a clip that will allow you to mount a L298N Motor Controller Board inside your project enclosure. The L298N is a very inexpensive (search on ebay), but capable dual motor controller. You can use it with a Raspberry Pi, Arduino or other micro controller. It allows you to use PWM, so it is super versatile.
This clip was designed in SketchUp from scratch, but was completely inspired by models from jwags55 (http://www.thingiverse.com/thing:511970 and http://www.thingiverse.com/thing:513629). I love the other clips made by jwags55 and did my best to replicate his great design.
The actual L298N board is approximately 43mm square. I originally modeled the clip to be 43mm wide (at the point where the board clips in), but this was too loose, so I reduced the width (at the point where the board clips in) to be approximately 42mm.
This clip was designed in SketchUp from scratch, but was completely inspired by models from jwags55 (http://www.thingiverse.com/thing:511970 and http://www.thingiverse.com/thing:513629). I love the other clips made by jwags55 and did my best to replicate his great design.
The actual L298N board is approximately 43mm square. I originally modeled the clip to be 43mm wide (at the point where the board clips in), but this was too loose, so I reduced the width (at the point where the board clips in) to be approximately 42mm.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!