Thingiverse
L96 barrel spacer
door ECO9FPV
139
Downloads
125
Likes
0
Makes
This is a basic L96 barrel spacer. It can be printed from 100% to 50%, it depends on your printer.
I printed it 100% with 0.3mm layer and 0.4 nozzle.
Flexible filament prefered, as it's a little bit wider and thiner to hold the inner barrel into the outer barrel. If you print it with PLA/ABS it's not gonna fit!
I printed a 15cm tower (change the Z value) and then you can cut it by cutter the size you preffer. By default it's 1cm.
To end with the smal filament it can get during travel it's good to apply a little bit of fire!
Share A Like!
I printed it 100% with 0.3mm layer and 0.4 nozzle.
Flexible filament prefered, as it's a little bit wider and thiner to hold the inner barrel into the outer barrel. If you print it with PLA/ABS it's not gonna fit!
I printed a 15cm tower (change the Z value) and then you can cut it by cutter the size you preffer. By default it's 1cm.
To end with the smal filament it can get during travel it's good to apply a little bit of fire!
Share A Like!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!