Thingiverse
Label for regal
by Toolix
0
Downloads
0
Likes
0
Makes
A label for a regal, mounted on a metal girder which holds the board.
On Github:
The label is designed for a regal girder with a height of 8 cm.
You have to print 2 parts, a top part and a bottom part.
You can print these without support.
Then you must assemble these 2 parts together.
You don't need any glue, both parts snap in.
You need 4 round magnets with size 10x1 mm.
Glue these on the back side into the holes.
You need a A4 paper.
Fold this paper twice an slide in by the slot in the side.
On Github:
The label is designed for a regal girder with a height of 8 cm.
You have to print 2 parts, a top part and a bottom part.
You can print these without support.
Then you must assemble these 2 parts together.
You don't need any glue, both parts snap in.
You need 4 round magnets with size 10x1 mm.
Glue these on the back side into the holes.
You need a A4 paper.
Fold this paper twice an slide in by the slot in the side.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
