Labrax 10" Rack Power Strip Brackets

There wasn't an official way to mount a power strip vertically in the back side of the LabRax 10 inch rack, so I came up with this design. Power strip dimensions: 40mm x 53mm Before printing, check for clearance if you have deep shelves on the 10" rack, this might get in the way. Hardware: Same screws and inserts used to assemble the rack: Two 4mm M6(OD 8mm) inserts: https://s.click.aliexpress.com/e/_c3U5Q7pb Two M6 10mm screws: https://s.click.aliexpress.com/e/_c4WnATNL