Labyrinth Puzzle with Fast Closure

There are already some labyrinth puzzle here. But all have the disadvantage that you have to solve the puzzle backwards to close.
Therefore, I have come up with a solution in which the runner pin is extended only after closing the cap. The pin is then locked in this state and can only be reset after the puzzle has been solved.

### Labyrint-Base1.stl
I modified the maze often shown here and made it a bit more difficult, especially at the beginning with a continuous ring. The shape can of course be used as a base for your own labyrinths.
I printed in 0.2mm layer height.

### Cap.stl
Forms the base of the cap, also printed in 0.2mm

### Slider.stl
This part is the closure part for the glider pin. Together with a spiral spring (e.g. from a ballpoint pen), it locks the glider pin in position.
Print in 0.1mm layer height so that the details are printed cleanly.

### Glider.stl
The core piece is this glider pin. It follows the paths of the maze. Since the details are very impo