Thingiverse
Lack corner tool rig
von Flotske
19
Downloads
9
Likes
2
Makes
This is a remix from the Corner Tool Holder by Igman79.
Thought that 2 side cutter holders was a bit to much so I added a caliper holder.
I found out that the side cutter holder was to big for the side cutter that came with the printer.
In file V2 the holder is a bit smaller so that it will fit.
Thought that 2 side cutter holders was a bit to much so I added a caliper holder.
I found out that the side cutter holder was to big for the side cutter that came with the printer.
In file V2 the holder is a bit smaller so that it will fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
