Thingiverse
Lack Enclosure Camera Mount
door jchaager
198
Downloads
111
Likes
0
Makes
Built this suspended camera mount for my IKEA Lack enclosure. Wanted something that gave an overall view of the print bed while not getting in the way. Because the pin doesn't fix the hinge, the camera is free to swing out of the way when you reach into the enclosure as well as auto adjust itself if you adjust the camera.
The base of the camera mounts is screwed to the underside of the table above the printer. The arm is then attached using either 3mmx30mm screws, or in my case, a 3mm wire pin. The camera screws onto the arm by way of a 1/4"x20x1/2" screw.
The base of the camera mounts is screwed to the underside of the table above the printer. The arm is then attached using either 3mmx30mm screws, or in my case, a 3mm wire pin. The camera screws onto the arm by way of a 1/4"x20x1/2" screw.
jchaager publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
