Lack Enclosure Door Hardware

Here's the final parts to my lack enclosure. I wanted to wait to release it as I was constantly modifying it in small ways to get it right where I wanted it… and then I forgot. But here it is, the hinges use a M4 screw and the handle uses M3 I believe. For full transparency I did not design the handle and backplate, and would love to cite where it's from, however the files have been floating around in my file library for so long that I have no idea where or when I found them. So if you stumble across this and you see it and think, “Wait a minute, that's my handle!!” Then shoot me a message and I will be happy to cite/link appropriately. And yes I could of taken a couple measurements and just whipped one up in Solidworks, but I still wouldn't feel right about it so hence the disclaimer. So for this, there are 4 plates. The first is the hinges, you'll need M4 screws for the actual hinge pin, and from there you can add a couple washers and a lock nut. Or I have the pul