Thingiverse
Lack enclosure Filament Guide
door stevesgoodprints
2
Downloads
0
Likes
0
Makes
**Filament Guide For Ikea Lack Enclosure**
I created this to solve the problem of the fialment bunching up when printing tall objects on my Mk4.
The bunching was caused by the small passthrough hole I originally used to feed the filament through the center of the lack enclosure. This design lets the filament feed into the enclosure with enought room for it to not bind or bunch up on tall prints.
I printed it in PETG, 0.2 layer height and it took approx 3 hours to print.
**Insert fits a hole cut to the size: 12mm x 262mm**
The dimensions and hole size needed are in the photos.
It will stick out slightly below the tabletop so there is enough room to put some hot glue or simial. (Althought its not needed)
I created this to solve the problem of the fialment bunching up when printing tall objects on my Mk4.
The bunching was caused by the small passthrough hole I originally used to feed the filament through the center of the lack enclosure. This design lets the filament feed into the enclosure with enought room for it to not bind or bunch up on tall prints.
I printed it in PETG, 0.2 layer height and it took approx 3 hours to print.
**Insert fits a hole cut to the size: 12mm x 262mm**
The dimensions and hole size needed are in the photos.
It will stick out slightly below the tabletop so there is enough room to put some hot glue or simial. (Althought its not needed)
stevesgoodprints publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
