LACK enclosure gap fillers

Credits to cisardom for thing
https://www.thingiverse.com/thing:2864118

and Mikolas Zuza for the guide
https://blog.prusaprinters.org/cheap-simple-3d-printer-enclosure/

I was a bit unhappy with the final build because cutting the plexi to 440 x 440mm left a gap between the LACK and plexi of aprox 5mm along each leg/vertical edge of the plexi. Due to the design of the plexi holders there will also be a 2mm gap on the horizontal edges.

So I made some simple gap fillers that fit quite nicely on my build. The STL files are for 3mm plexi cut to 440x440mm.

I attached a parametric 3ds file where you can adjust for plexi thickness and plexi length to some small degree.
NB - it will not change the length of the rails as they are static to the measures of the IKEA LACK. Adjusting L - length will simly make the groove deeper or shallower. Therefore you can only set values between 440mm and 432mm.

I also had to use a 1,5mm spacer in betweed the legs and bottom parts to mak