Thingiverse
lack enclosure table leg extender
di bluecraank
4
Download
0
Likes
0
Makes
This is a leg extender for a lack enclosure. Its 80mm height, so it fits for a ender 3 with anti vibration pads.
It is a easy design, so dont expect perfectly sized object.
Tips for installation:
Turn the table upside down
Put the extender onto the leg
pre-drill the holes (4mm)
now you can fasten it.
The other side, you need to put it about 1-2mm away from the edge, because the table itself is bigger than the legs are.
If you try to fasten it directly, it maybe will be out of center.
It is a easy design, so dont expect perfectly sized object.
Tips for installation:
Turn the table upside down
Put the extender onto the leg
pre-drill the holes (4mm)
now you can fasten it.
The other side, you need to put it about 1-2mm away from the edge, because the table itself is bigger than the legs are.
If you try to fasten it directly, it maybe will be out of center.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
