Lack Enclosure Wyze Camera Mount

I was trying to find a Wyze camera mount that would work with the Lack table enclosure I am building. I couldn't find one pre-made so I designed one for what I wanted it to do. Made it in fusion360.

I used the wyze camera mount as the sock for my camera (https://www.thingiverse.com/thing:3315051)

Unless your bridging is really well-tuned I would suggest adding support and if placed from corner to corner with the long edge on the table it will fit an ender 3 bed 235X235

Hardware needed.

4 (#6 screws 3/4in long)
2 - m3 x 8 flat screw
2 - m3x4x5 embedding nut

the m3's are used to attach the sock to the stand and you will need a soldering iron to embedded the nuts into the two holes.

the size 6 screws are what I used to attach it to the lack table enclosure.

Version 3 - released 12/15/2020 - Fixed the offset of the main bar so that it will sit flush on the table
Version 2 - release 12/14/2020 - Made the structures wider as too much sway in the thin arms in ver