Lack Leg Lifter

This is a super simple solution to a super simple problem. I needed to put the kids Christmas tree on a small table - the IKEA LACK table is almost perfect except it was just too short to put over the robot vacuum station. I quickly whipped up this simple model to raise the table slightly and safely. Simply print four of these and they are exactly the right dimensions to slip onto your table legs resulting in a lift of about 10cm.I printed in White (to match the table) ABS (for strength) with adaptive cubic infill. You could increase the infill if your table is going to be significantly heavier. The geometry is super simple and can scale to other leg sizes, no doubt.