Lack PowerSupply Mount

I built one of the Ikea LACK enclosures for my printer. I wanted to mount a 360W power supply under the printer. These parts are what I used to mount it.

I used a hole saw to drill two 1.5" holes through the lower table, one at the front and one at the back. I then mounted the power supply so that the exhaust blows up through the hole in the front and the power supply cables go up through the other.

I also used the power cable hole for a USB cable and I have a Raspberry Pi mounted on the underside of the printer stand as well.

I have the exhaust grill setup so that it blows towards the side wall. The reason I have the exhaust blowing into the enclosure is to help add warmth inside the case for printing ABS. I also have an exhaust fan on a temperature controller for keeping it from getting too hot inside the enclosure.

Honestly, the power supply doesn't seem to really add much heat to the enclosure.

You will need 4 of the power supply mounts and one of each of the other t