Lack Stack Kit - Table for Kids or Figurines

Inspired by Lack Printer Enclosure - LKM (shown in picture, right) I decided to make a table kit for my kids. A place for them to paint, read, do homework and such.

With the exterior honeycomb design and hidden locks, not only it increases the strength of the print it also look more attractive than ordinary plane designs. I think it will outlast the Ikea tables itself.

You can also use this to display your best prints and it can be a very nice companion for your Lack Enclosure!


===================
Note:

The parts should slide on with minimal friction and make sure you use some type of non oil based lubricant to avoid scratching the finish. I find that body lotion is a very good option, it does not soak into the material of the table and clean off easily too. Apply the lubricant on the parts, not the table legs. If the parts slide on too loose then wrap the table legs with 1-2 layers of tape at the location where the parts and table legs touches. Use the tapes as s