Thingiverse
Lack Table Bowden Tube Guide
by zcubed
34
Downloads
7
Likes
0
Makes
I recently got the MMU2 for my Prusa MK3 and needed to route 5 ptfe tubes from the mmu unit to above my Ikea Lack enclosure. This is my simple attempt at doing so. It just requires 2 M3 screws per tube. The tube hole may require some effort to get the ptfe in but it stays very secure once its in place.
There's 2 versions: One with an overhang which needs supports to print but is much more secure on the lack. The other is much more minimalist and requires no supports.
Works great as a combo with my Tush tube guide: https://www.thingiverse.com/thing:3129192
There's 2 versions: One with an overhang which needs supports to print but is much more secure on the lack. The other is much more minimalist and requires no supports.
Works great as a combo with my Tush tube guide: https://www.thingiverse.com/thing:3129192
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
