Thingiverse
LACK table corner connector
door fatgeekuk
7
Downloads
1
Likes
0
Makes
This is a corner connector, print out 4, glue then screw to the corners of the lower LACK table then fit the upper table in the constrained area. No hard connection to upper table so it can be moved easily when needed.
No support needed with the correct orientation, works fine in PETG.
No support needed with the correct orientation, works fine in PETG.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
