Thingiverse
LACK Table Enclosure Bracket
door CryptoCloaks
92
Downloads
48
Likes
1
Makes
This is a support bracket to hold the back panel of my Ikea LACK Table Enclosure on.
I ran a couple prints and they turned out great. The M5 hex nut fits snugly in the piece and will not fall out!
The screw hole is for a #8 screw
The Hex nut fits a M5 - .8mm
The screw spot allows me to mount it to the table while the hex nut allows me to screw the back panel in, to hold it in place.
I ran a couple prints and they turned out great. The M5 hex nut fits snugly in the piece and will not fall out!
The screw hole is for a #8 screw
The Hex nut fits a M5 - .8mm
The screw spot allows me to mount it to the table while the hex nut allows me to screw the back panel in, to hold it in place.
CryptoCloaks publiceert ook op
24 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
