Lack Table - PTFE Passthrough

This pass-through is for use with an IKEA Lack table enclosure. Using either an M6 or M10 PTFE connector, you can have your PTFE tubes from your MMU (or to your extruder directly if set up that way) exit the enclosure with minimal (if any) heat or moisture entering or exiting through the pass-through. As for orientation of the pass-through, it is designed to have the connector on the bottom (inside of enclosure).

The nut will work with either the M6 or M10 pass-through version. And each pass-through is threaded for the nut and the PTFE connectors. Making it much easier to get them threaded in correctly.

Supports are necessary, but they are very minimal. Only used for the lower portion to support the center tube. Additional information for supports in Print Settings.