Thingiverse
ladder cap
von zgroza199
0
Downloads
0
Likes
0
Makes
Standard ladder end cap
V1 - 72 x 28 mm hole -> should have plenty of clearance (designed for the bent end of the ladder)
V2 - 72 x 21 mm hole -> should fit nicely into the straight end of the ladder
I printed this with TPU from Devil Design, layer 0.16, infill 15%, 3 wall outlines. No support needed.
Printer Qidi Q1 Pro
V1 - 72 x 28 mm hole -> should have plenty of clearance (designed for the bent end of the ladder)
V2 - 72 x 21 mm hole -> should fit nicely into the straight end of the ladder
I printed this with TPU from Devil Design, layer 0.16, infill 15%, 3 wall outlines. No support needed.
Printer Qidi Q1 Pro
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
