Lambent Light Sheath

As my copy of Lambent Light nears completion, i decided it needed a sheath to carry it in at AnimeExpo. Designed to fit Camaleonte's remix of Microwavabletofoo's design. first of 4 pieces being printed now. Screenshot above shows the thick trim detail piece for scale.

.35mm layer height
160mm print height required
No support material needed

Edit: sheath fits the blade. Looks like there is space for foam lining to limit the sword rattling. I had some roughly 1/4 inch foam that i cut off about a 1.5 inch strip and glued to one side inside the sheath. it does help eliminate rattling quite a bit, but it was too tight to add on both sides. 1/16th in foam or so would be better.

Edited Sheath 1 section to make the detail a little bigger. just looked too small when printed.

Note: Battle tested, survived 2 full days at AX convention with no problem once i got enough CA superglue bonding the pieces together. glad i added the strip of foam lining to one side.