Thingiverse
Lamp holder
door alberto_da_meduna
11
Downloads
11
Likes
0
Makes
I have a bare lamp so I decided to make my own lampshade. The structure is in PLA, the rest is a simple masking tape which creates the light diffusion as with a common lampshade.
It is hold by the bulb. If it is not obvious, to install it, you need to remove the bulb and put it back with the lampshade on it (don't forget to switch off the light first).
It is hold by the bulb. If it is not obvious, to install it, you need to remove the bulb and put it back with the lampshade on it (don't forget to switch off the light first).
alberto_da_meduna publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
