Lamp wave design

Lamp wave design The lamp is designed suitable for E27 lamp fittings. As shown in the pictures, a screw mounting fitting is used to secure the lamp in place. The lamp has a screw in compartment at the bottom, this can be used to weight the lamp down (or can be used as a secret compartment for cash or other valuables). The print profile has the parts on two separate build plates, to easily print the parts in 2 colours without AMS. All parts fit on one build plate if needed. Assembly steps: Screw the fitting and the lamp on the connector. Feed the cable through the base and screw the base to the connector. Screw the shade on the connector. (only when you want to use the weighted bottom) load the compartment with your desired weight, and screw on the lid. Screw the weighted compartment in the base (mind the orientation of the cable, hold the cable in the slot at the underside of the base) If you like this design, please check out my other designs!