Thingiverse
Landing gear bracket for Multiplex FunCub
por MarenB
88
Descargas
52
Likes
2
Makes
Initial text:
This is a replacement for the genuine landing gear bracket of the famous Multiplex FunCub.
It is deivided into a few individual pieces to save support material. Just glue them together after printing.
Update 2016/07/03:
The first prototype was a close copy of the genuine part, but it turned out, that at least my printed part was not rigid enough. Two of the lugs holding the landing gear wire broke after the third not-so-soft landing.
So I made a reinforced version with longer lugs of increased cross section. I also added two holes on each side that can be used to add additional strenght by wrapping zip ties around the side lugs after the wire is installed.
This is a replacement for the genuine landing gear bracket of the famous Multiplex FunCub.
It is deivided into a few individual pieces to save support material. Just glue them together after printing.
Update 2016/07/03:
The first prototype was a close copy of the genuine part, but it turned out, that at least my printed part was not rigid enough. Two of the lugs holding the landing gear wire broke after the third not-so-soft landing.
So I made a reinforced version with longer lugs of increased cross section. I also added two holes on each side that can be used to add additional strenght by wrapping zip ties around the side lugs after the wire is installed.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!