Thingiverse
Landscape fabric staples
door galaxyman7
10
Downloads
7
Likes
0
Makes
Some landscape fabric staples, just to save a bit of money. At home depot a 75 pack of metal ones is $15. If you use some cheap $10 PLA or PETG, these come out to $2.70 per 75.
This is the 4th iteration on the design. I have tested them by hammering them into hard dirt multiple times, and they hold up great. They also hold in the soil pretty well.
I printed them in PETG with 3 outer shells and 15% gyroid infill. I also tested them in PLA and that works fine.
4th iteration:
Added ribs to both sides of each leg. This makes it so the legs don't spread out and crack the plastic as you hammer it in. I also sized it down a little since the larger ones seemed like overkill.
This is the 4th iteration on the design. I have tested them by hammering them into hard dirt multiple times, and they hold up great. They also hold in the soil pretty well.
I printed them in PETG with 3 outer shells and 15% gyroid infill. I also tested them in PLA and that works fine.
4th iteration:
Added ribs to both sides of each leg. This makes it so the legs don't spread out and crack the plastic as you hammer it in. I also sized it down a little since the larger ones seemed like overkill.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
