Slicer Discord
Langstroth 9 Frame Spacer (Bee Castle) – Modelo 3D imprimible de MakerWorld MakerWorld
Garden

Langstroth 9 Frame Spacer (Bee Castle)

por Chris · Garden
50 Descargas
21 Likes
35 Makes
Ver Modelo
This part locks in place snugly over Bee Castle (or other generic) Langstroth frames to provide leave-in spacing of 9 frames per 10-frame box.Running 9 frames in a 10 frame honey super allows for greater honey storage per-frame and the deeper cells make uncapping easier. I have only verified fitment on Bee Castle branded frames, which have a the following dimensions:Top Bar height (where the frame rests on the lip of the box) = 0.475" / 12mmSide Bar Width = 1.40" / 35.5mmSide Bar Thickness = 0.40" / 10mm These spacers are intended for use on 4 frames as follows (R = unmodified frame, S = frame with spacers on either end): |RSRSRSRSR|. You will still have adequate space on either side of the box; four spacers adds a total of 1.4" (35.5mm), equal to the width of one standard frame.The easiest way to install these spacers is to fully hook one side over the Side Bar, then carefully bend the spacer to pull the other side on and hook it over the side bar. Spacers fit snugly a
Categoría
Garden
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

Chris también publica en

861 modelos adicionales en 3 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección