Thingiverse
Laptop charger wrap (customisable)
door Angery_Rowlet
9
Downloads
15
Likes
0
Makes
A parametric holder for any large laptop charger. Cut a strip of double sided tape in half (or any other preferred adhesive) and stick to the bottom to attach it to the power brick. The power brick gets a bit warm but not hot enough to melt the adhesive.
To customise the length, adjust the "Loops" modifier in Fusion360. You can also adjust the thickness but I find that this is the sweet spot for strength, adhesion, and amount of material used
To customise the length, adjust the "Loops" modifier in Fusion360. You can also adjust the thickness but I find that this is the sweet spot for strength, adhesion, and amount of material used
Angery_Rowlet publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
