MakerWorld
Office
Go to Model
Laptop Holder
7
Downloads
2
Likes
2
Makes
So I have two laptops that I regularly use for coding on XCode and using modeling software, a mac and a dell. They are both 15.6 inch laptops but I imagine that as long as the laptop is relatively the same width it should work just fine. There is a small arch on the bottom to run cables if this is needed. I would recommend using supports if you want clean curves. It stands fine for me with one or two laptops in. Please shoot me any recommendations or wishes :) You could use felt pads if need be.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
