MakerWorld
Office
Go to Model
Laptop Riser/Laptop Stand
4
Downloads
3
Likes
1
Makes
Laptop riser/stand to elevate laptop screen in order to use it as a 2nd/3rd monitor. Brings the laptop screen closer to eye level and in-line with adjacent monitors. Front of the laptop sits approximately 4 inches (100 mm) above the desk surface and the laptop will be at a 30 degree angle. Laptop pictured is a 15" laptop. No supports are needed. The cross members fit into the left and right sides with a slight interference fit, but can still be taken apart if needed. Overall it is very sturdy. Model shown printed was printed in PLA. Boost MeI appreciate your support!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
