Laptop Stand

I found my Ciclop 3D Scanner to be more useful as a laptop stand, so I harvested the metal parts and made this. I eventually wanted my laptop at an angle, so I modeled a middle section of my own, but you can still use the ciclop center tower and just bend the rods to achieve the same effect.

I included my very messy SCAD, in case you want to change the angle or dimensions.

3D Printed Parts:
1x left foot
1x right foot
1x front support
1x center tower

Metal (or Nylon) Parts:
4x M8x170 mm threaded rod
2x M8x235 mm threaded rod (I trimmed the 400mm rods that come with the ciclop)
24x m8 nut
18x m8 washer

Other Parts:
1.5mm EVA Foam
Double Sided Tape or Spray Adhesive (Supper 77) to affix the foam to the bottom of feet and tower, and if you want the front support.