Thingiverse
Laptop Stand
door KonosV
2.4k
Downloads
2.3k
Likes
6
Makes
Stand for 14'' laptops such as lenovo ideaflex.
The angle of the stand is 20 degrees.
To assemble the stand you will also need 4X 16mm M3 screws.
At the bottom of each bracket there are 3 slots in which you can glue 10mm rubber feet. I advice you to do so because most 3d printed plastics are quite sllipery on most surfaces.
The angle of the stand is 20 degrees.
To assemble the stand you will also need 4X 16mm M3 screws.
At the bottom of each bracket there are 3 slots in which you can glue 10mm rubber feet. I advice you to do so because most 3d printed plastics are quite sllipery on most surfaces.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
