Gadgets
Zum Modell
Laptop stand
271
Downloads
213
Likes
1
Makes
I improved the creator's support to be able to adapt it better to my 17" MSI (it's not big enough), I widened the middle piece to have a good hold on the sides of my pc and I I made supports for the feet to have a better balance towards the back to prevent it from tipping over.
You must print 2*: Support_PC_Laptop_Foot support.stl
Dimensions:
- 17.2 cm width between the two feet, total width 22.5cm
- 2.5 cm widths of a foot, with a length of 19 cm
- 20 degree angle
- author at the lowest 6 cm
For assembly you can put hot glue to hold the pieces together
You must print 2*: Support_PC_Laptop_Foot support.stl
Dimensions:
- 17.2 cm width between the two feet, total width 22.5cm
- 2.5 cm widths of a foot, with a length of 19 cm
- 20 degree angle
- author at the lowest 6 cm
For assembly you can put hot glue to hold the pieces together
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!