Laptop Stand With Drawer

I had a laptop stand, but I wanted to see if I could make the space underneath more useful by adding a drawer. It is printed in 5 pieces. In an attempt to avoid using supports as much as possible, the front face of the drawer is printed separately from the drawer and is simply attached with glue. For the side frames, I print those laid on the side with the dove tail connections towards the top to again avoid using supports as much as possible.The actual drawer will likely need a small amount of supports to ensure that it prints cleanly and doesn't cause interference with the guide rail for the drawer. I printed it with support using Bambu PLASupport material for the interface. The dovetails to attach the side frames with the base plate are not pressure fit, so you will need to glue those together.Print SettingsPrinter: Bambu X1CRafts: NoSupports: Yes (Only on the drawer)Resolution: 0.2Infill: Gyroid 10%