Thingiverse
Laptop tilt riser / vertical stand
por DyLaron
60
Descargas
51
Likes
2
Makes
For laptop computer. ranged from 11" to 15" screen size.
In the riser mode the hinge is raised to about 6" from the desk surface.
It's a design with two 3d-printed side plates, connected with 2 rods (bars, or tubes) of 0.5" diameter. (In the pictures I used a 0.75" plastic rod in an earlier prototype, it is an overkill, so I changed the model to half inch). You could choose to print out such a bar as well.
In the model there are bumps at the tip of the hook, for better holding the front end of laptop down. (not shown in my photos)
The two 'things files' are mirror image of each other. You can down both, or download one, and do the mirror in the slicing software.
In the riser mode the hinge is raised to about 6" from the desk surface.
It's a design with two 3d-printed side plates, connected with 2 rods (bars, or tubes) of 0.5" diameter. (In the pictures I used a 0.75" plastic rod in an earlier prototype, it is an overkill, so I changed the model to half inch). You could choose to print out such a bar as well.
In the model there are bumps at the tip of the hook, for better holding the front end of laptop down. (not shown in my photos)
The two 'things files' are mirror image of each other. You can down both, or download one, and do the mirror in the slicing software.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
