Laptop Vertical Stand

Remix of 'dmpmassive' design and dimensions adjusted for holding the laptop in a vertical open position. Designed for up to 14mm thickness (While opened) which is most laptops.
Mine specifically was a Dell Latitude 7300.

Two benefits:
1. Better position to actually use the laptop screen as an additional monitor
2. Cooling (Bottom of laptop now exposed to more freely gathered air)

Print in current orientation with supports to help with arch.
(I set my overhang setting in Cura to 50 degrees and also put a couple support blockers on the left and right to reduce the support just a little (1 blocker width).

Might be safer printing with brim or raft too so the overhand does not collapse inward before it joins with support.

Note: I don't use the laptop keyboard or touchpad as I have external keyboard and mouse.

Will print on Ender 3 as 220mm wide (If you still have trouble, rotate it 45 degrees in cura and it will fit in with plenty to spare)