Thingiverse
Laptop Wedge
door doughnutVan
85
Downloads
89
Likes
2
Makes
This is a laptop wedge/stand that I made in an effort to raise my gaming laptop up from the desk juuuust enough to give it more airflow. My secondary goal was to also make it so that the hot air blowing out the back didn't necessarily get sucked back in to the cooling fans.
I have two versions that I uploaded:
1 - More side holes for airflow, aggressive wedge, harder to print, first iteration of this wedge
2 - Less side holes for airflow, more rigid, easier to print, second iteration of this wedge
NOTE: I would HIGHLY suggest using a glue stick to ensure that all the hexagons print properly on the first layer. Supports should not be needed.
I have two versions that I uploaded:
1 - More side holes for airflow, aggressive wedge, harder to print, first iteration of this wedge
2 - Less side holes for airflow, more rigid, easier to print, second iteration of this wedge
NOTE: I would HIGHLY suggest using a glue stick to ensure that all the hexagons print properly on the first layer. Supports should not be needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
