Thingiverse
Large Destiny ghost LED holder
von Preppy9924
0
Downloads
2
Likes
0
Makes
Basically looks like a little flower tea light that touches the neg and pos of the battery when turned.
Pre bend the LED then put the neg in the center and positive on the outside.
No need to resize should be the same, I use elephant foot comp of 0.1 and 3 walls, 0.4 nozzle, 0.2 layer height, 15% infil grid, 235 abs.
I printed the led holder upside down, and the switch/battery holder upright with supports on both.
Thank you to BoldPrintShop, and Girotz for originals.
Pre bend the LED then put the neg in the center and positive on the outside.
No need to resize should be the same, I use elephant foot comp of 0.1 and 3 walls, 0.4 nozzle, 0.2 layer height, 15% infil grid, 235 abs.
I printed the led holder upside down, and the switch/battery holder upright with supports on both.
Thank you to BoldPrintShop, and Girotz for originals.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
