Thingiverse
Large Drag Chain
von chronomex
3
Downloads
10
Likes
0
Makes
I originally tried to build http://www.thingiverse.com/thing:973 , but RepSnapper disagreed with its geometry.
This drag chain link is 45mm wide, 29mm deep, and 77mm long overall. The cross-section of the usable volume is 27mm wide and 25mm deep. Each link has a useful length of 60mm.
It took about 45 minutes to print a single link with RepSnapper on a Mendel. I printed two in a pre-assembled orientation and they fused, but separately printed ones snapp together with a little effort.
This drag chain link is 45mm wide, 29mm deep, and 77mm long overall. The cross-section of the usable volume is 27mm wide and 25mm deep. Each link has a useful length of 60mm.
It took about 45 minutes to print a single link with RepSnapper on a Mendel. I printed two in a pre-assembled orientation and they fused, but separately printed ones snapp together with a little effort.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
