Thingiverse
Large Tablet Stand (dual Angle)
by gibbon_
10
Downloads
9
Likes
0
Makes
This tablet stand was created to support an iPad pro on a desk and have it still usable without tipping it over. Most stands that only support the tablet at the bottom pose a risk of the whole thing tipping over or put a lot of load on the bezel or display.
This stand is roughly 15cm high and can support tablets up to 11mm thick. It is not recommended to use tablets higher than 25cm on this stand. Please check how safely the device can be used before relying on it.
Tilt angles of the tablet are 12° and 18°
This stand is roughly 15cm high and can support tablets up to 11mm thick. It is not recommended to use tablets higher than 25cm on this stand. Please check how safely the device can be used before relying on it.
Tilt angles of the tablet are 12° and 18°
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
