Large vase insert/holder for Brick built flowers

I had a large vase that I wanted to put my brick flowers in to display them, but as it was they would not sit as it was too deep and wide, so i created this simple insert that would hold them at the right height and angle allowing me to add a few more over time when I got more. The base hole that the insert will fit measures about 61mm in diameter and the outer edge is 74mm, height is about 91mm, the holes for the flowers are 8mm so just enough so they don't move around and there are 13 holes allowing you to space several as you need. If you have a vase that is a different diameter and you want me to create one a bit bigger or smaller, let me know and I will try and add a profile of it to suit! Prints with no supports, only 21g of filament and in about an hour. If you find this useful leave a review and a boost if you can!