Laser Engraver Mount

I have a direct drive extruder and wanted a way to mount a laser module to the rear of the motor in a way that does not interfere with the Titan Extruder on the front of the motor. The mount can be screw on to the rear of the motor by remove 2 opposing screws and running them through the mount and into the motor. You then mount the laser module into the mount and secure it with a 3.5mm screw turned finger tight. I recommend drilling all hole to your desired screw size in case your printer is not perfect with screw holes.

Recommended material: PETG or ABS.

NOTE: PLA may work but may soften if the laser module housing heats up on extended engraving.