MakerWorld
Other Tools
Go to Model
Laser Engraver Part Alignment Jig
70
Downloads
27
Likes
44
Makes
I needed a jig / guide to help place bookmark blanks in the same position for engraving. Double sided tape can be used to hold it down to the waste board. Inner edges measure 40mm and 100mm and have a relief cut to allow a snug fit into the corner.
Ken Mills also publishes on
328 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
