Thingiverse
Lasercut bottle holder for drying
von poohma
6
Downloads
7
Likes
1
Makes
This is a bottle holder for 0.5L bottles for drying my water-bottle at work.
The hole for the bottle is 4cm in diameter so it should fit most bottles.
I used 4mm Poppel finèr (plywood?), any 4mm wood should work.
3 or 5 mm will probably work but will look a bit off... you can then use sandpaper to smooth out the jagged edges.
Assemble with care, the hinge cuts might need to be softened with water.
The hole for the bottle is 4cm in diameter so it should fit most bottles.
I used 4mm Poppel finèr (plywood?), any 4mm wood should work.
3 or 5 mm will probably work but will look a bit off... you can then use sandpaper to smooth out the jagged edges.
Assemble with care, the hinge cuts might need to be softened with water.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
